autocast universal
®
230 Casting System Crowns and bridges Stand 1.9. 03 A 2
Muffle System
To avoid gas entrapment during casting, the sprue cone
must be of a certain shape. Use only the muffle bases
belonging to the system with sprue formers.
Muffle base with sprue former:
Size 3 1 piece Ord.-No. 106-850-01
Size 6 1 piece Ord.-No. 106-851-01
Size 9 1 piece Ord.-No. 106-852-01
The base plate must be completely clean.
Distance between wax frame and investment surface:
max. 6 mm.
Wax-Up
To achieve a clean and rapid melt flow, joints of the sprue
cone and onto the pattern should be smooth and round.
Align the pattern horizontally.
Keep the distance from the edge of the muffle approx. 6 mm.
The pattern should lie with its upper edge 6 mm below the
edge of the muffle rings. Consequently the length of the
main supply sprue will be 15–20 mm.
Wax: Reducing Tension
Before pressing the silicone rings over the base plate spray
the wax patterns with Lubrofilm
®
(Ord.-No.112-050-00) and
blow dry.
Muffle rings, flexible
Size 3 1 piece Ord.-No. 106-840-00
Size 6 1 piece Ord.-No. 106-841-00
Size 9 1 piece Ord.-No. 106-842-00
Use the muffle rings corresponding to the size of the muffle
base.
Investing
In order to obtain perfect fitting castings, the handling
instructions for rematitan
®
Plus investment must be strictly
followed.
Required amount of rematitan
®
Plus investment:
For muffle size 3 1 x 250 g
For muffle size 6 2 x 250 g
For muffle size 9 3 x 250 g
rematitan
®
Plus investment should only be mixed with the
special mixing liquid Ord.-no. 107-602-00.
Store the mixing liquid in the refrigerator at about 8–10°C/
46–50°F (not in the freezer compartment).
If outside temperature is high, powder should be cooled
also. Working time approx. 3 minutes 15 seconds at about
23°C/73°F.
Comentarios a estos manuales