Diamond Systems Tritan Instrucciones de operaciones descargar pdf (Pagina 30)

autocast universal

230 Casting System Model casting Stand 1.9. 03 A 23

7. Spruing system

In the upper jaw, attach 2 sprue channels of 4 mm diameter

in the form of a v in the dorsal region. Length of the sprue

channels are approx. 10 mm.

The standard spruing system is used in the lower jaw.

(see page A 11)

8. Preparation for investing

The models are trimmed on the side to the waxed portions.

The subsequent standing surface of the model is trimmed at

an angle of 45°. Distance from the waxed model to the base

surface approx. 4 mm. In contrast to conventional titanium

model casting, the upper jaw one-piece casting models are

waxed onto the base plate at an angle of 45°.

Lower jaw refractory models are waxed as usual.

9. Muffle ring

The blue muffle ring for all upper jaw models.

The red or blue muffle ring for all lower jaw models.

With models waxed-up at an angle of 45°, the undercut

areas on the investment model are filled with rematitan

Plus investment using a large brush before mounting the

muffle ring. This prevents from bubbles on the wax model.

Setting time 40 minutes. Peel off the muffle base.

10. Investing

For the upper jaw (blue muffle), 3 x 250 g packs are required.

Mixing ratio = 750 g : 120 ml.

11. Standing times, holding times,

temperatures

The parameters for the rematitan

casting system instructions

apply (page A 4 and A 20–21).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 89 90

Sin comentarios

Diamond Systems Tritan Instrucciones de operaciones Pagina 30